[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 86: htmlspecialchars(): charset `utf8-bin' not supported, assuming utf-8
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 151: htmlspecialchars(): charset `utf8-bin' not supported, assuming utf-8
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 152: htmlspecialchars(): charset `utf8-bin' not supported, assuming utf-8
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/user.php on line 329: htmlspecialchars(): charset `utf8-bin' not supported, assuming utf-8
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
DesignCAD DC Toolkit FileLinker Forum • [gelöst] Wandstärke in unterschiedlichem Maßstab
Seite 1 von 1

[gelöst] Wandstärke in unterschiedlichem Maßstab

Verfasst: Dienstag 23. März 2021, 11:51
von Spike
Hallo, ich benutze DC Toolkit und DC 2D, beide Version V29
Problem: wenn ich einen Hausgrundriß (erstellt vor ca. 2 Jahren mit Vers. 28) mit Toolkit bearbeite, z.B. eine Wand mit 115 mm Stärke zeichne, wird sie um den Faktor ca. 10 zu groß gezeichnet.
Nur mit DC gezeichnet mit eingestellter Wandstärke 11.5 ist alles ok. Merkwürdig ist, daß bei einem anderen, etwa gleichzeitig gezeichneten Grundriß kein Unterschied auftritt. Wo muß ich "Feintuning" vornehmen? Kann jemand weiterhelfen? Habe schon etliche Einstellungen getestet.

Re: Wandstärke in unterschiedlichem Maßstab

Verfasst: Mittwoch 14. April 2021, 08:53
von DcUser
Hallo,

die Maßstab-Einstellung in DC Toolkit überprüfen. Wahrscheinlich ist hier der Maßstab 1:10 eingestellt.