[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 86: htmlspecialchars(): charset `utf8-bin' not supported, assuming utf-8
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 151: htmlspecialchars(): charset `utf8-bin' not supported, assuming utf-8
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 152: htmlspecialchars(): charset `utf8-bin' not supported, assuming utf-8
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/user.php on line 329: htmlspecialchars(): charset `utf8-bin' not supported, assuming utf-8
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
DesignCAD DC Toolkit FileLinker Forum • Wandstärke einstellen
Seite 1 von 1

Wandstärke einstellen

Verfasst: Samstag 22. September 2018, 21:59
von Keiner
Kann man mit Version 27 die Wandstärke von Objekten bestimmen?

Re: Wandstärke einstellen

Verfasst: Montag 24. September 2018, 14:29
von DcUser
Hallo,
die Frage ist leider ein wenig unspezifisch. Betrifft die Frage die Raumplanung, den 3D-Druck oder einen anderen Bereich?

Re: Wandstärke einstellen

Verfasst: Mittwoch 3. Oktober 2018, 10:26
von Keiner
Einfachstes Beispiel: Ein Kubus. Mit Designspark-Mechanical ist es ein Klacks, eine Wandstärke (nach Entfernen einer Aussenfläche) einzugeben, und die auch jederzeit editieren zu können. Geht das in V27?
In Designcad3d V26 gibt's die Wandstärke nur für das Rohr, die man später aber leider nicht mehr editieren kann...

Im Hauptforum für Designcad3d gab's für ein ähnliches Problem (die Wandstärke von (hab's vergessen)) eine abenteuerliche Antwort.
Da es jetzt Designcad3d max V27 als Sonderangebot gibt, ist es für mich eine wichtige Frage.

Gruss

Re: Wandstärke einstellen

Verfasst: Donnerstag 4. Oktober 2018, 22:43
von DcUser
Es gibt in DesignCAD keinen Befehl, der im 3D-Bereich automatisch von einem Facetten- oder Volumenmodell eine Aussen- oder Innenkontur erstellt. Wenn, dann erfolgt das in DesignCAD immer konstruktionstechnisch. DesignCAD hat keinen parametrischen Kernel.