[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 86: htmlspecialchars(): Charset "utf8-bin" is not supported, assuming UTF-8
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 151: htmlspecialchars(): Charset "utf8-bin" is not supported, assuming UTF-8
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 152: htmlspecialchars(): Charset "utf8-bin" is not supported, assuming UTF-8
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/user.php on line 329: htmlspecialchars(): Charset "utf8-bin" is not supported, assuming UTF-8
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
DesignCAD DC Toolkit FileLinker Forum • Bemassungstextgrösse festlegen

DesignCAD DC Toolkit FileLinker Forum

Das User Forum für DesignCAD, DC Toolkit und FileLinker Anwender
https://dws-helpdesk.de/forum/

Bemassungstextgrösse festlegen

https://dws-helpdesk.de/forum/viewtopic.php?f=4&t=415

Seite 1 von 1

Bemassungstextgrösse festlegen

Verfasst: Mittwoch 2. Dezember 2020, 06:59
von Kollega
Wie kann ich die Bemassungstextgrösse zu Beginn der Zeichnung festlegen.( z.b. 5)
Obwohl ich in den "Optionen" ," Bemassung" die Grösse 5 festlege ist beim nächsten Bemassungsschritt wieder 35 eingetragen.

Descad V. 26

Re: Bemassungstextgrösse festlegen

Verfasst: Mittwoch 2. Dezember 2020, 15:28
von DcUser
Hallo,

in den DesignCAD Optionen auf die Schaltfläche Speichern klicken - oder (wenn DC Toolkit eingesetzt wird), den Maßstab ändern.
Alle Zeiten sind UTC+01:00
Seite 1 von 1

Powered by phpBB® Forum Software © phpBB Limited

Deutsche Übersetzung durch phpBB.de