[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 86: htmlspecialchars(): charset `utf8-bin' not supported, assuming utf-8
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 151: htmlspecialchars(): charset `utf8-bin' not supported, assuming utf-8
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 152: htmlspecialchars(): charset `utf8-bin' not supported, assuming utf-8
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/user.php on line 329: htmlspecialchars(): charset `utf8-bin' not supported, assuming utf-8
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4130: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3009)
DesignCAD DC Toolkit FileLinker Forum • Konstruktionsebenen-Bug?
Seite 1 von 1

Konstruktionsebenen-Bug?

Verfasst: Donnerstag 13. Juni 2019, 01:08
von JohW
Beim Definieren von Konstruktionsebenen kämpfe ich die letzten Tage mit einem seltsamen Verhalten. Das Arbeiten mit selbst definierten K-Ebenen klappte bisher problemlos. Nun habe ich aber das Problem, dass manche Körper beim Umschalten zwischen verschiedenen Konstruktionsebenen sich nicht entsprechend der Definition der K-Ebenen in ihrer Orientierung verändern, sondern quasi in jeder Konstruktionsebene gleich drinliegen. Aber der Fehler tritt nur bei Körpern auf, die durch Addition von 2 anderen Körpern entstanden sind. Gerade habe ich herausgefunden, dass das Problem wohl mit der Einstellung "Flächenmodell für Volumenbearbeitung benutzen" (bei Optionen / Allgemein) und "Festen Oberfächen" zusammenhängt. Schalte ich die Option aus und addiere die Körper erneut, dann hat der Spuk ein Ende. Das scheint ein Bug zu sein.